NLHB BEARINGS

Engineering Tool

Equivalent Load Calculator

Calculate equivalent dynamic load P = X·Fr + Y·Fa. Deep groove factors are interpolated from f0·Fa/C0. Angular contact factors follow the contact angle.

Input

Bearing type and applied loads.

For deep groove ball bearings, f0 is in the bearing maker's table and is often about 12–16. If you do not have it, 14 gives a close estimate. Single row angular contact: a radial load creates an internal axial force, so Fa must include it. Double row or pair: enter the loads on the whole set, and use the rating of the whole set for life.

Results

—kN
Equivalent dynamic load P
Fa / C0 —
f0 · Fa / C0 —
Fa / Fr —
Limiting factor e —
X factor —
Y factor —
Axial active? —
Formula:
If Fa/Fr ≤ e: P = Fr
If Fa/Fr > e: P = X·Fr + Y·Fa
Double row or DB/DF pair: Fa/Fr ≤ e gives P = Fr + Y1·Fa; Fa/Fr > e gives P = X·Fr + Y2·Fa.
Deep groove and 15° angular contact: e and Y are interpolated linearly.

X/Y Factor Reference Table — Deep Groove Ball Bearings

f0·Fa/C0eFa/Fr ≤ eFa/Fr > e
XYXY

Source: ISO 281 / bearing maker catalogues. Values for single-row deep groove ball bearings with normal clearance. Values between rows are interpolated.

X/Y Factor Reference Table — Angular Contact Ball Bearings

Contact angleeFa/Fr ≤ eFa/Fr > e
XYXY

15° single row: factors by Fa/C0

Fa/C0eFa/Fr ≤ eFa/Fr > e
XYXY

Source: bearing maker catalogues. Some makers use their own contact angles and factors. If your bearing table lists factors, use those. Values for 15° are interpolated between rows.

How it works: The equivalent dynamic load P combines radial and axial loads into a single load value for bearing life calculation. For deep groove ball bearings, X and Y depend on f0·Fa/C0, which also sets the limiting value e. When Fa/Fr exceeds e, the axial load must be included in the calculation. For angular contact ball bearings, the factors depend on the contact angle, and a double row bearing always counts the axial load. For cylindrical roller bearings (no axial capacity), P = Fr always. If you do not know the contact angle, ask the bearing maker: a smaller angle gives a higher P at the same load. Next step: calculate bearing life.

Read the guide

Inquiry List 0

Your Inquiry List

Submit All as Quote →